Skip to main content
  1. HomeHomeBreadcrumb divier
  2. Hygiene ManagementBreadcrumb divier
  3. Sensors & GatewaysBreadcrumb divier
  4. How to change the network settings of the WGT-11

How to change the network settings of the WGT-11

Highlightbox

This article describes how to connect to the WGT-11 and configure the network settings according to your infrastructure.

Solution

1. Connect to the WGT-11

There are three ways to connect to the WGT-11:


A. Connection via Wi-Fi

  1. Connect to the Wi-Fi (SSID):
    rational-xxxxxx
  2. Password:
    rational1234
  3. Open the following address in your browser:
    http://10.130.1.1


B. Connection via the LAN Network

  1. Connect to the local network where the WGT-11 is located
  2. Determine the via DHCP assigned IP address of the WGT-11 (e.g., via the router)
  3. Open the following address in your browser:
    http://IP-ADDRESS-OF-THE-WGT-11


C. Direct Connection via Network Cable

  1. Connect your notebook directly to the WGT-11 using an RJ45 network cable
  2. Configure the network interface of your notebook as follows:
    • IP Address: 172.31.255.253
    • Subnet Mask: 255.255.255.252
  4. Open the following address in your browser:
    http://172.31.255.254


2. Login

  • Username: root
  • Password: dragino
    (or use your own credentials)


3. Configure Network Settings

  1. Navigate to: Network → Network
  2. By default, the WGT-11 is set to DHCP.
  3. Change the 'Mode' to 'Static' and adjust the network settings accordingly
  4. Save the changes: Click Save & Apply


4. Example View

Example_Network_WGT-11



Next Steps

After successful configuration, you can use the gateway in your network and continue configuring it via the assigned IP address if needed.

Was this resource helpful?

Related Articles

Setup of the WGT-11 LoRaWAN GatewayLink icon
Contact

Contact Support.

Let us know how we can help you more.